Securam ProLogic L22 Operating Instructions Manual page 17

ProLogic L22
Step 4: Scroll  to the menu selection "System Menu" and Press OK.
Step 5: Enter Manager code.
Step 6: Scroll  to "Show Audit Trail".
The Audit Trail will be displayed on the LCD as shown below. You can scroll through the audit
events by pressing the  and .
8.0 Single or Dual Control
The ProLogic L22 has the ability to operate in either Single Control mode or Dual Control Mode:

Single Control Mode: One valid code will open the safe lock system.

Dual Control Mode: Two valid codes must be entered to open the safe lock system.
The ProLogic L22 comes pre-programmed in Single Control Mode.
8.1 Enable Dual Mode
Step1: Press the Menu/OK button.
Step 2: Using the and , scroll to the System Menu and Press OK.
Step 3: The display will prompt you to enter a valid code. Enter either the Super Code (ID00) or
the Manager Code (ID01). The "Select Menu" message will be displayed as follows:
Step 4: Scroll  to the menu selection "Enable Dual Mode" and Press OK.
Operation Instructions
17