PaloAlto Networks PA-7000 Series Hardware Reference Manual page 50

PA-7000 Series Firewall Module and Interface Card Informaon
Item Component
2 LED dashboard
3 LFC installaon and
removal hardware
Interpret the PA-7000 Series LFC LEDs
Use the following informaon to learn how to interpret the LED dashboard and port LEDs located
on the Log Forwarding Card (LFC).
LED
PWR (POWER)
PA-7000 Series Firewall Hardware Reference
Descripon
Ports 1 and 9 share the same LED and ports 5 and 10
share the same LED. Port transfer rate is differenated
by color. Green indicates 10Gbps and yellow indicates
40Gbps.
PAN-OS 9.1 and earlier:
You can only use ports 1 or 9 in PAN-OS versions 9.1 and
prior. Ports 2-8 and 10 are not available. Configuring the
LFC as lfc1/1 operates the first interface as port 1 at 10G
(Green LED). Configuring the LFC as lfc1/9 operates the
first interface as port 9 at 40G (Yellow LED). The second
interface is not used in either configuraon. The LFC does
not support LAG and LACP.
Five LEDs that provide LFC status. For details on the
LEDs, see
Forwarding Card (LFC)
Screws and levers used to install and remove the LFC.
There are thumb screws and double lever release latches
on each side of the card. Each inner ever contains a micro-
switch and when you simultaneously pull both inner
levers outward to release the outer ejector
State Descripon
Green The LFC is powered.
Off The LFC power is off.
Interpret the PA-7000 Series Firewall Log
LEDs.
50
2021 Palo Alto Networks, Inc.
©