PaloAlto Networks PA-7000 Series Hardware Reference Manual page 167

Service the PA-7000 Series Firewall Hardware
STEP 6 | Gently press the two clips to release the mSATA. Once the mSATA pops up, carefully remove
it from the socket.
STEP 7 |
Carefully place the new mSATA into the socket. Ensure that the label displaying the Palo Alto
Networks SKU and bar codes is facing up. Press the mSATA down unl it clicks into place
and is secured by both clips.
STEP 8 | Detach your wrist strap's ground cable from the ESD surface and plug the banana clip back
into one of the ESD ports on the front of the chassis. While the card ejector levers are ajar,
gently slide the SMC back into the appropriate slot in the chassis. Ensure that the SMC
faceplate aligns with the faceplates of the other cards.
STEP 9 | Lock the card ejector levers and screw the SMC screws back into the front of the chassis.
STEP 10 | Reconnect the power cords and SMC cables.
PA-7000 Series Firewall Hardware Reference
167
2021 Palo Alto Networks, Inc.
©