PaloAlto Networks PA-7000 Series Hardware Reference Manual page 112

PA-7000 Series Firewall Installaon
STEP 2 | Put the provided ESD wrist strap on your wrist ensuring that the metal contact is touching
your skin. Then aach (snap) one end of the ground cable to the wrist strap and remove the
alligator clip from the banana clip on the other end of the ESD grounding cable. Plug the
banana clip end into one of the ESD ports located on the front of the chassis before handling
ESD sensive hardware. For details on the ESD port locaon, see
STEP 3 |
Remove the two nuts and star washers from the ground studs located on the back of the
chassis on the upper le side.
STEP 4 | Crimp a 6-AWG wire to the grounding lug and connect the other end to your earth ground
point.
STEP 5 |
Connect the two-post lug connector to the two-post studs on the chassis using the provided
star washers and nuts and then torque the nuts to 50 in-lbs. You can install the lug in a
vercal or horizontal posion. Be careful not to strip the threads on the nuts and lug studs.
Figure 8: PA-7080 Ground Cable Connection
PA-7000 Series Firewall Hardware Reference
112
PA-7080 Front Panel (AC).
2021 Palo Alto Networks, Inc.
©