Pc Connection; Manager Management; Dynamic Codes - Enabling/Disabling - Tecnosicurezza TechMaster User Instructions

TechMaster
Press to confirm or
At the end of the list, press

PC connection

Use this function to enable the connection between the keypad and PC.
Power up the keypad. Enter the Master menu. Press
displays:
Press to start the connection with PC.
Press to stop the connection with PC.
If the static codes have been deleted, PC connection can be enabled by using the dynamic
user AUDIT.

Manager Management

Power up the keypad. Enter Master menu. Press
displays:
Press . LCD displays:
" " installed, "_" deleted, "X" disabled.
Select Manager by entering its reference number and press
If the Manager is not installed, LCD displays:
Press to confirm. Then enter the new Manager code and confirm
it. LCD displays:
If the Manager is already installed, press
disabling/deleting/installing it. Then press
Dynamic codes – Enabling/Disabling
WARNING: it is recommended to always perform this operation with door open, to
enable/disable the dynamic codes. Later, dynamic codes can be activated through the red
Dallas key 1971 previously programmed with the software Dyama or DyamaWeb.
Power up the keypad. Enter Master menu. Press
displays:
Press . LCD displays:
IU_TechMaster_05_eng
to exit.
.
for
to confirm.
until LCD
until the LCD
.
until the LCD
ENABLED/DISABLED
User instructions
END OF LIST
EXIT?
PC LINK
PC LINK
...
MANAGER
MANAGEMENT

1 MANAGER

2 AMMINISTRAT.
01
INSTALL?
OPERATION DONE
DYNAMIC CODES
DYNAMIC CODES
17 of 28