Time And Date Recovery Through Dyamaweb (Otc Software); Time Lock Settings - Tecnosicurezza TechMaster User Instructions

TechMaster

Time and Date recovery through DyamaWeb (OTC software)

This option can only be used after activating the dynamic codes and the deletion of all static
codes (including the Master code). For further information, see the paragraph Dynamic
codes activation with static codes deleting, pg. 18. This option allows for the updating of
the time and date values by using the keypad along with the DyamaWeb software. (for
further information, see user manual IU_DyamaWeb_XX or IU_DyamaWebLite_XX).
Power up the keypad and press and hold
version is shown.
Press until the LCD displays the current time and date.
Press and hold . LCD displays:
Insert the blue Dallas key N1971 in the reader. LCD displays:
Enter the 8-digits code displayed on the LCD into DyamaWeb software,
to generate the dynamic code to access the Time & Date menu, to
update time and date values.
Press . LCD displays:
Enter the dynamic code generated by DyamaWeb software: LCD
displays the current values for time and date.
Press to enter the new time and date values and press
confirm.
DST Settings
WARNING: it is recommended to enter this menu always with the door
open.
Power up the keypad. Enter the Master menu. Press
displays:
Press one time and then press
Press again to confirm.
If the static codes have been deleted, automatic DST can be enabled by using the dynamic
user DST.

Time Lock settings

WARNING:
It is recommended to enter this menu always with the door open;
Master menu, allows to add/delete the settings for time lock/closing periods/opening
periods, only if current time and date values are included in an opening period.
IU_TechMaster_05_eng
until the keypad firmware
until LCD
to select between ON and OFF.
User instructions
08:00 FRI
01/27/2006
TIME/DATE ERROR
MODE ACTIVATED!
TIME/DATE ERROR
XXXX XXXX
DYNAMIC CODE
X X X X X X X X X
to
AUTOMATIC DST
13 of 28