Tesla RoboStar T80 Pro Manual page 44

Press the button
cleaning brushes work.
To control the water flow during wet wiping, press the button on the remote control
preset value will be displayed on the display.
1. Low water dripping intensity
2. Secondary water drip rate (factory set value)
3. High water drip intensity
The water drips automatically, so do not let the vacuum cleaner stand in a place without movement
or with any residual water in the water tank to prevent spillage of water on the floor.
DRY MOPPING

Used to remove fine dust and polish the floor, use a dry mopping cloth.
 Do not use the microfiber mop for wiping on carpets and uneven surfaces.
to start wiping with water. In this mode, vacuuming is switched off, only side
Open the plastic cap and take the water into
the plastic water tank. We recommend that
the floor be wiped with clean water, the
detergent may cause foam to soften water
dripping on the mop, or cause smudges on
the floor after drying.
Install the blue mopping fabric on the
bottom with the water tank. Lightly dampen
the mopping fabric for a faster and
smoother wiping. When removing the mop
from the holder, make sure you do not
damage the velcro fastener on the bracket
quickly.
If the mop is dirty after cleaning, you can
clean it with lukewarm water.
Remove the dirt trap from the unit and
insert the water tank.
and the