Brake Fluid - BRP LYNX Commander 800R E-TEC Touratech Operator's Manual

mmo2010-009-001_a
1. Opening
2. Feeler gauge
6. Place feeler gauge between engine
stopper and rubber stop block (on
engine).
NOTE: Do not insert the feeler gauge
too deep, as it will pass over the bump
at the surface of the rubber stop block
and alter adjustment. See illustration.
mmo2010-009-002_a
1. Rubber stop block
2. Bump
3. Feeler gauge
7. Tighten screws to the specified
torque, following the illustrated se-
quence. Take care not to pinch the
feeler gauge.
mmo2010-009-007_b
TIGHTENING SEQUENCE
TIGHTENING TORQUE
Stopper
screws
NOTICE
can occur if the engine stopper and
its screws are not properly installed.

Brake Fluid

Recommended Fluid
Use only DOT 4 brake fluid from a
sealed container. An opened container
may be contaminated or may have ab-
sorbed moisture from the air.
Use only DOT 4 brake fluid from a
sealed container. To avoid serious
damage to the braking system, do
not use fluids other than the rec-
ommended one, nor mix different
fluids for topping up.
NOTICE
painted and plastic parts. Handle
with care. Rinse thoroughly in case
of spillage.
Brake Fluid Level
Place vehicle on a level surface.
Check brake fluid (DOT 4) in reservoir
for proper level. Add fluid (DOT 4) as
required.
_______________
MAINTENANCE PROCEDURES
10 N•m ± 2 N•m
(89 lbf•in ± 18 lbf•in)
Serious pulley damage
WARNING
Brake fluid can damage
87