Vehicle Warm-Up - BRP LYNX Commander 800R E-TEC Touratech Operator's Manual

mmo2008-005-007
3. Attach the other end of emergency
rope to the starter clip supplied in
the tool kit.
mmo2008-005-009
4. Hook up clip on drive pulley.
mmo2008-005-012_a
1. Clip installation location
5. Wind the rope tightly around drive
pulley. When pulled, pulley must
rotate counterclockwise.
mmo2008-005-014_a
6. Pull the rope using a sharp, crisp pull
so the rope comes free of the drive
pulley.
When starting the snowmobile
in an emergency situation, using
drive pulley, do not reinstall the
belt guard and return slowly to
have snowmobile repaired.

Vehicle Warm-Up

Before every ride, vehicle has to be
warmed up as follows:
1. Start engine as explained in
STARTING PROCEDURE
2. Allow engine to warm up one or two
minutes at idle speed.
NOTE: It is not recommended to let
engine running at idle speed for more
than 10 minutes. Engine will shut
down after approximately 12 minutes
of idling.
3. Disengage parking brake.
4. Apply throttle until drive pulley en-
gages. Drive at low speed the first
two or three minutes.
_______________
OPERATING INSTRUCTIONS
WARNING
ENGINE
above.
67