Suspension - BRP LYNX Commander 800R E-TEC Touratech Operator's Manual

MAINTENANCE PROCEDURES
A01F05A
1. Guides
2. Slider shoes
3. Equal distance
If off center, perform alignment as fol-
lows:
WARNING
Remove the tether cord cap from
engine cut-off switch before per-
forming any maintenance or ad-
justment, unless otherwise spec-
ified. Vehicle must be parked in a
safe place, away from the trail.
1. Remove the tether cord cap from
engine cut-off switch.
2. Loosen rear idler wheel retaining
bolts.
3. Tighten the adjustment bolt on side
where the slider shoe is the farthest
from the track insert guides.
1
3
A01F0BA
1. Guides
2. Slider shoes
3. Tighten on this side
4. Tighten lock nuts.
5. Tighten idler wheels retaining bolts
to specified torque.
______________
96
1
2
3
2 1
TIGHTENING TORQUE
Idler wheel
bolts (35 lbf•ft ± 4 lbf•ft)
WARNING
Make sure all fasteners are prop-
erly tightened to avoid loosing an
idler wheel or causing the track to
lock.
A05F0EB
TYPICAL
1. Locknut
2. Retaining bolts
6. Start engine and rotate track slowly
to recheck alignment.
7. Reposition snowmobile on ground.
8. Install rear wheel caps if so
equipped.

Suspension

Rear Suspension Condition
Visually inspect all suspension compo-
nents including slider shoes, springs,
wheels, etc.
NOTE: During normal driving, snow
will act as a lubricant and coolant for
the slider shoes. Extensive riding on
ice or sanded snow, will create exces-
sive heat build-up and cause prema-
ture slider shoe wear.
48 N•m ± 6 N•m
1
2