BRP LYNX Commander 800R E-TEC Touratech Operator's Manual page 92

MAINTENANCE PROCEDURES
5. If a new belt was installed, adjust
the belt height. Refer to
BELT HEIGHT ADJUSTMENT
low.
6. Install belt guard, refer to
BELT GUARD INSTALLATION
7. Close side panel, refer to
PANELS CONTROLS, INSTRU-
in
MENTS AND EQUIPMENT
Drive Belt Height Adjustment
The drive belt height must be checked
every time a new belt is installed.
To adjust the drive belt height, proceed
as follows:
1. Remove the tether cord cap from
engine cut-off switch.
2. Open LH side panel, refer to
PANELS CONTROLS, INSTRU-
in
MENTS AND EQUIPMENT
tion.
3. Remove belt guard, refer to
BELT GUARD REMOVAL
4. Loosen the clamping bolt.
mmo2011-003-010_a
ALUMINUM ADJUSTER HUB
1. Adjuster hub
2. Clamping bolt
5. Using the suspension adjustment
tool provided in the tool kit, turn the
ring 1/4 turn at a time then rotate the
driven pulley to properly set the belt
between the pulley sheaves.
______________
90
DRIVE
be-
DRIVE
.
SIDE
.
mmo2011-003-011_a
ALUMINUM ADJUSTER HUB
1. Suspension adjustment tool
NOTE: The adjustment ring has left
hand treads.
Belt without External Cogs
Repeat step 5 until the external sur-
face of drive belt exceeds driven pulley
edge by 0mm.
SIDE
subsec-
DRIVE
.
mmr2009-081-001_a
PRELIMINARY SETTING
A. 0mm
Belt with External Cogs
Repeat step 5 until the bottom of
grooves on the external side of drive
belt are flush with the driven pulley
edges.
mmr2008-040-108_a
PRELIMINARY SETTING
1. Driven pulley edge
2. External drive belt grooves