Unpacking And Installation Instructions For 480Ra Version - Kodak HEALTH SCIENCES MINILOADER 2 Plus Stand-alone Installation Instructions Manual

INSTALLATION INSTRUCTIONS

UNPACKING AND INSTALLATION INSTRUCTIONS FOR 480RA VERSION.

1. Remove the BANDING from the PACKING CASE then lift the CARTON off the MINILOADER
PALETTE.
2. Remove the MAGAZINES from the top of the MINILOADER and unpack them.
The case should contain:-
PARTNo. QUANT
xxxxxxxx
30023169
30023168
30026197
30023197
30026262
30015540
30015564
30015612
30025844
30025845
30025846
30025848
30025849
30026265
3. Fit the four LEVELLING SCREWS (30025846) to the tapped HOLES in the BASE of the
MINILOADER.
4. Remove the LID and lift the MINILOADER onto its STAND. Drawings of suitable STANDS are shown
in APPENDIX "A".
!! CAUTION TWO PEOPLE
5. If the STAND is metal, an earth connection must be made between the STAND and the MINILOADER..
IMPORTANT - ENSURE THE PAINT IS REMOVED WHERE THE EARTH CONNECTION IS
MADE.
7. Remove the left hand SIDE PANEL from the MINILOADER.
December 1992
DESCRIPTION
1 MINILOADER 2 PLUS VERSION 480RA
1 SUPPLY MAGAZINE 18x24 CM
1 SUPPLY MAGAZINE 24x30 CM
1 SUPPLY MAGAZINE 8x10 INCH
1 SERIAL UNLOADING MAGAZINE 18x24 CM
1 SERIAL UNLOADING MAGAZINE 24x30 CM
2 SCREW, M4 x 30 (USED TO FASTEN MINILOADER TO PROCESSOR)
2 NUT, M4 (USED TO FASTEN MINILOADER TO PROCESSOR)
2 NUT, THIN, M4 (USED TO FASTEN MINILOADER TO PROCESSOR)
2 KEYS FOR INTERLOCK OVERRIDE (INSIDE MINILOADER)
4 LARGE DIAMETER WASHER M4 (USED TO FASTEN MINI TO PROC)
4 SCREW, HEXAGON HEAD, M8 x 40 (MINILOADER LEVELLING FEET)
4 WASHER, FLAT, M8
1 CAN OF TOUCH-UP PAINT
1 PIN 6 x 35 MM (INSIDE MINILOADER)
ARE
Page II-13
REQUIRED TO LIFT THE MINILOADER !!
II 3239
© Kodak Ltd.