Kodak HEALTH SCIENCES MINILOADER 2 Plus Stand-alone Installation Instructions Manual page 15

Hide thumbs Also See for HEALTH SCIENCES MINILOADER 2 Plus Stand-alone:

INSTALLATION INSTRUCTIONS

11.

Align the MINILOADER and PROCESSOR horizontally as shown in figure 16, fit the other two M4

LARGE DIAMETER WASHERS and the M4 NUTS. Do not tighten the NUTS yet. It is very important

to have the alignment correct, especially for an RA PROCESSOR because the CHUTE EXTENSION can

interfere with the LED's inside the FILM ENTRY.

Figure 16

HORIZONTAL

ALIGNMENT

12.

By adjusting the LEVELLING SCREWS on the MINILOADER, (and the PROCESSOR if necessary),

set the height of the MINILOADER. The vertical alignment is correct when a FILM hits the lower EN-

TRY ROLLER 1.5 mm below the nip of the ROLLERS. See figure 17.

Figure 17

VERTICAL

ALIGNMENT

13.

When both horizontal and vertical alignments are correct, tighten the M4 NUTS.

14.

Go to the INSTALLATION CHECK LIST on page II-22 of this publication to complete the installation..

December 1992

PLAN VIEW

MINILOADER

Film

1.5 mm

Page II-15

PROCESSOR

Align the two frames here.

Entry rollers

of processor

II 3239

Table of Contents