Video Cassette Preparation - Kodak HEALTH SCIENCES MINILOADER 2 Plus Stand-alone Installation Instructions Manual

INSTALLATION INSTRUCTIONS

VIDEO CASSETTE PREPARATION.

All MINILOADER CASSETTES must be patched correctly otherwise reliable operation is impossible.
The correct PATCHES are PART NUMBER 9194551, REFLECTIVE FOIL 8 x 15 mm. Fit one PATCH as
shown below in figure 25. If MODIFICATION 2 is active, fit a second PATCH on the opposite side. There are
no PATCHES inside VIDEO CASSETTES.
Figure 25
All cassettes
must have a
patch on
this side
To prevent FILMS sticking to the FRAME of the VIDEO FILM HOLDER, self adhesive FELT PADS can be
attached to the FRAME. The FELT PADS need to be cut to a length of 6 mm and fastened to the CASSETTE
as shown below in figure 26. There are ten FELT PADS in a kit, and they are supplied with installation
instructions.
The part number of the FELT PAD KIT is 9166451.
Figure 26
December 1992 Page II-21
II 3239
If modification 2 is
active, a second
patch must be fitted
here.
© Kodak Ltd.