Kodak HEALTH SCIENCES MINILOADER 2 Plus Stand-alone Installation Instructions Manual page 12

II 3239
Figure 13.
New clear panel
(30026252)
Countersunk
screw 6
22. Position the MINILOADER and STAND in front of the M35-M. Pull the Miniloader over the PROCESSOR
(lifting it slightly to clear the STOPS). Fasten the CABLE RETAINING BLOCK to the PROCESSOR
REAR PANEL using the SCREWS provided. See FIGURE 14. Check that the CABLE is not strained when
the MINILOADER is pulled forward to its STOPS. Lay the LIGHT BAFFLE in position on the top of the
PROCESSOR. Plug in the two FLYING LEADS for PHOTOCELL FC9 and STAND-BY OVER-RIDE.
Pull the MINILOADER into its fully docked position and ensure the relative heights of the MINILOADER
and PROCESSOR are correct. Adjust if necessary.
Figure 14
23. Complete the installation of the M35-M PROCESSOR, using the M35-M INSTALLATION MANUAL.
IMPORTANT, THE M35-M MUST BE INSTALLED IN ACCORDANCE WITH THE M35-M
INSTALLATION MANUAL AND ADDITIONALLY IN ACCORDANCE WITH LOCAL
PRACTICES. Then go to the INSTALLATION CHECK LIST on page II-22 of this PUBLICATION.
© Kodak Ltd.
Countersunk
screws 4 & 5
Countersunk
screw 7
Page II-12
INSTALLATION INSTRUCTIONS
New metal plate
(30015562)
Countersunk screw 8
(no cup washer here)
Cable retaining
block
Light baffle
Flying
leads
December 1992