Kodak HEALTH SCIENCES MINILOADER 2 Plus Stand-alone Installation Instructions Manual page 8

Hide thumbs Also See for HEALTH SCIENCES MINILOADER 2 Plus Stand-alone:

II 3239

15.

Mount the six aluminium RETAINING BLOCKS on the top of the PROCESSOR FRAME as shown in

FIGURE 5.

132

394

All dimensions in mm.

16.

Refit the EXHAUST ADAPTOR (removed in step 5) to the new PROCESSOR REAR PANEL using the

existing HARDWARE. Fit the new REAR PANEL to the PROCESSOR using the original SCREWS

etc. Connect the EARTH LEAD from the PANEL to the M35-M ELECTRICAL BOX as shown in

FIGURE 6. Refit the STAND-BY/RUN SWITCH. Reconnect the M35-M EXHAUST HOSE to the

EXHAUST ADAPTOR.

Figure 6

Wash

Electrical box

INSTALLATION INSTRUCTIONS

215

Fix

Dev

215

New rear panel

Page II-8

Figure 5

Blocks mount this way up.

Earth lead

December 1992

Table of Contents