Kodak HEALTH SCIENCES MINILOADER 2 Plus Stand-alone Installation Instructions Manual page 6

II 3239
7. Roll the STAND away and install the PROCESSOR on the PLINTH, the front of the PROCESSOR
towards the front of the STAND, and secure it using the SCREWS supplied with the PROCESSOR and
the M10 STAR WASHERS supplied in the kit. See FIGURE 3. IMPORTANT, MAKE SURE THERE
IS NO PAINT ON THE PROCESSOR PLINTH WHERE THE STAR WASHERS CONNECT.
FIGURE 3
New M10 star
washers
8. Remove the BANDING from the smaller PACKING CASE then lift the CARTON off the
MINILOADER PALETTE.
9. Remove the MAGAZINES from the top of the MINILOADER and unpack them.
The case should contain:-
PARTNo. QUANT
xxxxxxxx
30023169
30023168
30026197
30023197
30026262
30025844
30025849
30026265
10. Remove the LID and lift the MINILOADER onto its STAND. The front of the MINILOADER is at
the front of the STAND. IMPORTANT - ONLY LIFT THE MINILOADER BY THE FRAME AS
SHOWN IN FIGURE 4.
© Kodak Ltd.
Original processor
levelling screws
DESCRIPTION
1 MINILOADER 2 PLUS M35-M VERSION
1 SUPPLY MAGAZINE 18x24 CM
1 SUPPLY MAGAZINE 24x30 CM
1 SUPPLY MAGAZINE 8x10 INCH
1 SERIAL UNLOADING MAGAZINE 18x24 CM
1 SERIAL UNLOADING MAGAZINE 24x30 CM
2 KEYS FOR INTERLOCK OVERRIDE (INSIDE MINILOADER)
1 CAN OF TOUCH-UP PAINT
1 PIN 6 x 35 MM (INSIDE MINILOADER)
INSTALLATION INSTRUCTIONS
Page II-6 December 1992