Mounting The Enclosure Outdoors; Figure 2-2. Enclosure Mounting Holes - ADTRAN Total Access 374 Installation And Maintenance Manual

Total Access 374 4-POTS, 4-GigE MDU ONT Installation and Maintenance Guide

Mounting the Enclosure Outdoors

Use an appropriately sized screw to fit properly in the diameter of the mounting holes (see
Figure
opening the door. Complete the following steps to mount the enclosure:
1. Choose a vertical surface near an approved ground, but away from down spouts, perma-
2. Refer to
3. Pre-drill the marked locations and install fasteners or anchors appropriate to the
4. Mount the ONT to the side of the subscriber's premise.
NOTE
Consideration should be given to allow proper clearance for opening the
ONT door.
2-6
2-2). Make sure to leave a minimum clearance of 2 inches (5.1 cm) from the hinges for
nent water sprinklers, or other water sources. The subscriber should have easy access for
testing.
Figure 2-2 and use the top and bottom Mounting Holes as a template to mark
fastener locations. Use a level to ensure the unit is level to prevent warping.
mounting surface (each anchor rated to 15 lbs. minimum).

Figure 2-2. Enclosure Mounting Holes

Mounting
Hole
Mounting
Hole
Mounting
Hole
61287703G1-5B