Installing The Flat Glass Draft Shield; Installing A Device; With A Frame Draft Shield; Positioning The Weighing Pan And Associated Components - Sartorius Cubis MCA Series Operating Instructions Manual

Installation
1
50 Operating Instructions Cubis
5.7.3

Installing the Flat Glass Draft Shield

Procedure
Gently tilt the upper panel down. This enables the upper panel to slide
t
completely into the slot (1).
Slide the upper panel completely into the slot.
t
Insert the side panel completely into the guide rails on the weighing
t
module (2) and into the upper guide rails (1).
1
2
5.8 Installing a Device with a Frame Draft Shield
5.8.1 Positioning the Weighing Pan
and Associated Components
Procedure
Insert the pin on the pan support into the clip on the pan retainer.
t
Push the pan support down onto the pan retainer until the pan support
t
lies parallel to the device housing.
MCA
®