Setup; Installing The Steering Wheel (International Models Only); Checking The Fluid Levels And Tire Pressure - Toro Workman GTX Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Installing the Steering
Wheel (International Models
Only)
Parts needed for this procedure:
1 Steering wheel
1 Steering wheel cover
1 Washer (1/2 inch)
1 Dust cover
Procedure
1. If the cover is installed, remove it from the hub
of the steering wheel
2. Remove the locknut (1/2 inch) from the steering
shaft (Figure 3).
3. Slide the steering wheel, dust cover, and washer
(1/2 inch) onto the steering shaft
Note:
With the front wheels straight, orient the
steering wheel so that the smaller spoke on the
steering wheel is vertical.
Description
Steering wheel
Steering wheel cover
Washer (1/2 inch)
Dust cover
No parts required
No parts required
Operator's Manual
Engine owner's manual
Registration card
Predelivery Inspection Form
Certificate of Quality
Key
(Figure 3).
(Figure
Qty.
1
1
1
1
–
–
1
1
1
1
1
2
4. Secure the steering wheel to the shaft with the
locknut (1/2 inch) and tighten it to 18 to 30 N∙m
(13 to 22 ft-lb).
5. Install the cover on the steering wheel
1. Steering wheel cover
2. Locknut (1/2 inch)
3. Washer (1/2 inch)
3).
9
Use
Install the steering wheel (International
models only).
Check the fluid levels and tire pressure.
Burnish (break-in) the brakes.
Read the Operator's Manual and view
the setup material before operating the
machine.
Figure 3
4. Steering wheel
5. Dust cover
6. Steering shaft
(Figure 3).
g198932