Burnishing The Brakes; Reading The Manual And Viewing The Setup Material - Toro Workman GTX Operator's Manual

2
Checking the Fluid Levels
and Tire Pressure
No Parts Required
Procedure
1. Check the water level in the batteries before
you operate the machine; refer to
Water Level of the Batteries (page
2. Ensure that the batteries are charged; refer to
Charging the Batteries (page
3. Check the brake-fluid level before you operate
the machine; refer to
Level (page 45).
4. Check the air pressure in the tires; refer to
Checking the Tire Pressure (page
3

Burnishing the Brakes

No Parts Required
Procedure
To ensure optimum performance of the brake system,
burnish (break-in) the brakes before use.
1. Bring the machine up to full speed, apply the
brakes to rapidly stop the machine without
locking up the tires.
2. Repeat this procedure 10 times, waiting 1 minute
between stops, to avoid overheating the brakes.
Important:
This procedure is most effective
if the machine is loaded with 227 kg (500 lb).
Checking the
38).
36).
Checking the Brake-Fluid
16).
4
Reading the Manual and
Viewing the Setup Material
Parts needed for this procedure:
1 Operator's Manual
1 Engine owner's manual
1 Registration card
1 Predelivery Inspection Form
1 Certificate of Quality
2 Key
Procedure
•
Read the Operator's Manual and the engine
owner's manual.
•
Fill out the registration card.
•
Complete the Predelivery Inspection Form.
•
Review the Certificate of Quality.
10