Toro Workman GTX Operator's Manual page 37

3. Connect a 16 gauge (or larger diameter),
2.5 m (8.2 ft) or shorter charger cord to the
charging receptacle on the machine
Note:
Ensure that the charger-voltage setting
matches the voltage at the power outlet being
used.
Note:
In high-ambient temperature
environments, remove the seat assembly for
optimal charging time; refer to
Seat Assembly (page
is too hot, it may not charge properly. In cold
temperatures, it may take a longer for the
batteries to charge.
Figure 38
1. Charger-status light
2. Charging receptacle
3. The battery is near empty.
4. Plug the charger power cord into the power
outlet.
Note:
While the batteries are charging, the
green light on the charger blinks on and off.
When the batteries are fully charged, the green
light stops blinking and stays on.
5. Disconnect the cord from the power outlet.
6. Disconnect the charger from the machine.
(Figure
Removing the
30). If the battery charger
4. The battery is almost
charged.
5. The battery is charged.
6. Charger fault; refer to the
charger manual for the
fault codes.
Refer to the following table and
information on the meanings of the varying colors of
38). the charger-status light.
Charger-Status Light Table
Charger-Status
Light Color
Green
Green
Amber
Red
g034217
37
Figure 38
Solid/Flashing
Solid Charging complete
Flashing Short flash—less
than 80% charge
Long
flash—greater than
80% charge
Flashing Reduced-power
mode—low AC
voltage or high
internal charger
temperature;
charge immediately
Flashing Charger
error—reset the
charger power
If this error persists,
refer to the blink
codes in the
charger manual
for
Meaning