Storage; Storage Safety; Storing The Machine - Toro Workman GTX Operator's Manual

Storage

Storage Safety

•
Shut off the machine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.

Storing the Machine

1. Park the machine on a level surface, engage the
parking brake, shut off the machine, and remove
the key.
2. Clean dirt and grime from the entire machine,
including the outside of the motor housing.
Important:
You can wash the machine
with mild detergent and water. Do not use
high pressure water to wash the machine.
Pressure washing may damage the electrical
system or wash away necessary grease at
friction points. Avoid excessive use of water,
especially near the control panel, lights,
motor, and the battery.
3. Inspect the brakes; refer to
Parking Brake (page
4. Check the tire pressure; refer to
Tire Pressure (page
5. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
6. Paint all scratched or bare metal surfaces.
Note:
Paint is available from your Authorized
Service Dealer.
7. Store the machine in a clean, dry garage or
storage area.
8. Remove the key and put it in a safe place out of
the reach of children.
9. Cover the machine to protect it and keep it clean.
Battery Storage
1. Charge the batteries fully before placing the
machine into storage; refer to
Batteries (page 36). Plug the charger into a wall
outlet while the machine and batteries are in
storage. Leave the charger plugged into a wall
outlet and charging receptacle during storage
to ensure that the batteries stay charged and
do not freeze; otherwise, charge the batteries
monthly at a minimum.
Checking the
44).
Checking the
16).
Charging the
2. Plug in the charger during storage to maintain
full battery life.
Important:
plugged in during storage, fully charge the
batteries at least once a month. The batteries
self-discharge over long periods of time,
which may damage the batteries to the point
of being unusable, even if the batteries are
new.
3. After fully charging the batteries, fill the batteries
with distilled or deionized water before storing;
refer to Adding Distilled or Deionized Water to
the Batteries (page
48
If the machine cannot be
38).