Ethernet And Console Ports - Aerohive Networks AP121 Hardware Reference Manual

Table 1 HiveManager component descriptions (Continued)
Component
AC Power Inlet
On/Off Switch
Power Fan

Ethernet and Console Ports

The two 10/100/1000-Mbps Ethernet ports on the HiveManager labeled MGT and LAN use standard RJ-45
connector pin assignments that follow the TIA/EIA-568-B standard (see
of Ethernet cable—cat3, cat5, cat5e, or cat6. Because the ports have autosensing capabilities, the wiring
termination in the Ethernet cables can be either straight-through or cross-over.
Figure 2 Ethernet port LEDs and pin assignments
(View of an Ethernet port on
the HiveManager)
Link rate LED
Dark: 10 Mbps
Green: 100 Mbps
Amber: 1000 Mbps
The Ethernet ports are auto-sensing and can automatically adjust to transmit and receive data over straight-through
or cross-over Ethernet connections. For a diagram showing T568A and T568B wiring, see
Ports" on page 42.
The default IP address/netmask for the MGT interface is 192.168.2.10/24. For the LAN interface, the
default IP address/netmask is 192.168.3.10/24. The IP address of the default gateway is 192.168.2.1.
The pin assignments in the male DB-9 console port follow the EIA (Electronic Industries Alliance) RS-232
standard. To make a serial connection between your management system and the console port on the
HiveManager, you can use a null modem serial cable, use another serial cable that complies with the RS-232
standard, or refer to the pin-to-signal mapping shown in
Connect one end of the cable to the console port on the HiveManager and the other end to the serial (or
COM) port on your management system. The management system must have a VT100 terminal emulation
program, such as Tera Term Pro
®
Windows operating systems).
Hardware Reference Guide
Description
The three-prong AC power inlet is a C14 chassis plug through which you can
connect a HiveManager to a 100 – 240-volt AC power source using the
10-amp/125-volt IEC power cord that ships with the product.
The on ( | ) and off (  ) switch controls the power to the HiveManager.
The fan that maintains the temperature of the power supply.
Link activity LED
Dark: Link is down
Steady amber: Link is up
but inactive.
Blinking amber: Link is up
and active
8 1
Pin numbers
©
(a free terminal emulator) or Hilgraeve Hyperterminal
Figure 2). They accept standard types
10/100Base-T
Pin Data Signal
1 Transmit +
2 Transmit -
3 Receive +
4 (unused)
5 (unused)
6 Receive -
7 (unused)
8 (unused)
Legend: BI_D = bidirectional
A+/A-, B+/B-, C+/C-, D+/D- = wire pairings
Figure 3 on page 94 to make your own serial cable.
P O
RODUCT VERVIEW
1000Base-T
Data Signal
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-
"Ethernet and Console
®
(provided with
93