Aerohive Networks AP121 Hardware Reference Manual page 103

Chapter 10 The High Capacity HiveManager
7. From the front of the equipment rack, guide the chassis rails on the sides of the HiveManager into the
inner slides. Then push the HiveManager into the rack until the front mounting brackets are flush against
the front rack rails.
8. Using four screws—two for each of the front brackets—fasten the HiveManager to the equipment rack
as shown in Figure 6. If the rack has round holes, use the two remaining bar nuts (and locator pins) and
thread the screws through the rack rails into them.
Figure 6 Mounting the HiveManager in an equipment rack
Rack rails
Rear
mounting
Outer slide
bracket
The HiveManager is now securely mounted to the front and rear rails of the equipment rack.
102
Inner slide
(over the
chassis rail)
Front
mounting
bracket
Screws
Aerohive