Plenum Mount - Aerohive Networks AP121 Hardware Reference Manual

Plenum Mount

To mount the AP340 in the plenum space above a dropped ceiling grid, you need the mounting plate,
hanger clip, and a standard 24"-wide hanger frame, which can be ordered separately (SKU#
AH-ACC-BKT-PLENUM).
1. With the recessed side of the mounting plate facing downward, insert the hanger clip through the large
hole in the center of the plate.
2. Squeeze the clip until the projecting tabs at the ends of its two feet snap into the smaller holes on both
sides of the larger hole (see
Figure 12 Fitting the hanger clip to the mounting plate
1
Insert the hanger clip through the large hole in
the mounting plate.
Squeeze the hanger clip to pull the tabs on the
2
feet inward until they snap upward into the two
holes on either side of the larger hole.
3. Attach the AP340 to the mounting plate, and then attach the antennas to the connectors (see
Figure 13).
Figure 13 Attaching the AP340 to the mounting plate
3
Align the V-shaped tabs on the
mounting bracket with the tab
slots on the bottom of the AP.
Insert the V-shaped tabs into the
tab slots until they click into place.
4
Attach external antennas, if they
are required. (The AP shown
here uses internal antennas.)
4. Remove the ceiling tile next to the area where you want to mount the device.
5. Press the hanger frame downward into place on the ceiling track until the claws on each leg grips the
track below the top ridge (see
Hardware Reference Guide
Figure 12).
Mounting plate
V-shaped tab
Tab slot
Figure 14).
Hanger clip
Hanger clip
M AP340
OUNTING THE
V-shaped tab
Tab slot
77