Aerohive Networks AP121 Hardware Reference Manual page 10

Table 1 AP121 and AP141 component descriptions (Continued)
Component
Console Port
Power Connector
ETH0 10/100/1000
Mbps Port
Reset Button
USB Port
Security Tab Cavity
and Security Screw
Device Lock Slot
Hardware Reference Guide
Description
You can access the CLI by making a serial connection to the RJ-45 console port.
The management station from which you connect to the device must have a VT100
emulation program, such as Tera Term Pro
®
Hyperterminal (provided with Windows
Windows XP). The serial connection settings are: bits per second: 9600, data bits: 8,
parity: none, stop bits: 1, flow control: none. For details, see
Ports" on page 10.
There are two ways to power an AP121 or AP141 devices. You can connect a
device to a 100 – 240-volt AC power source by connecting an AC/DC power
adaptor (available as an extra option) to the 12 V (1.1A) DC connector. You can
also power the device through the ETH0 port from PSE (power sourcing equipment)
that is compatible with the 802.3af and 802.3at standards. Because there is no
on/off switch, these devices automatically power on when you connect them to
power.
The 10/100/1000-Mbps Ethernet port—ETH0—receives an RJ-45 connector. The AP
can receive power through an Ethernet connection to the ETH0 port from PSE that is
compatible with the 802.3af standard. Aerohive provides suitable PoE injectors as
an optional accessory. (If you connect the AP to a power source through the
power connector and the ETH0 PoE port simultaneously, the device draws power
through the power connector and automatically disables PoE.)
The ETH0 port is compatible with 10/100/1000Base-T/TX and automatically
negotiates half- and full-duplex connections with the connecting device. It is
autosensing and adjusts to straight-through and cross-over Ethernet cables
automatically. For details, see
The reset button allows you to reboot the device or reset it to its factory default
settings. Insert a paper clip, or similar tool, into the Reset pinhole and press the reset
button. To reboot the device, hold the button down for 5 seconds. To return the
configuration to the factory default settings, hold it down for at least 10 seconds.
After releasing the button, the indicator light goes dark, and then glows steady
amber while the firmware loads and the system performs a self-test. After the
software finishes loading and the AP has connected to HiveManager, the status
indicator glows steady white.
To disable the reset button from resetting the configuration, enter this command: no
reset-button reset-config-enable Pressing the button for 5 seconds will still
reboot the AP, but pressing it for more than 10 seconds will not reset its
configuration.
Reserved for future use.
When mounting the AP on a ceiling track or flat surface, insert the security tab
extension on the rail mount or mounting plate into the security tab cavity and then
fasten the AP to the mounting equipment by inserting the security screw through
the security screw hole and tightening it. See
page 14.
You can physically secure the AP by attaching a lock and cable (such as a
®
Kensington notebook lock) to the device lock slot.
AP121
©
(a free terminal emulator) or Hilgraeve
®
operating systems from Windows 95 to
"Ethernet and Console Ports" on page
"Locking the AP121 and AP141" on
AP141 P O
AND RODUCT VERVIEW
"Ethernet and Console
10.
9