Locking The Ap121 And Ap141 - Aerohive Networks AP121 Hardware Reference Manual

Chapter 1 AP121 and AP141 Platforms

Locking the AP121 and AP141

To lock the AP to the rail mount or mounting plate, use either a Kensington lock or the security screw that is
included with the mounting kit. To use a Kensington lock, loop the cable attached to the lock around a
secure object, insert the T-bar component of the lock into the device lock slot on the AP, and then turn the
key to engage the lock mechanism.
To lock the AP to the rail mounting bracket or mounting plate, you can use either the slotted screw or the
pan-head security screw, both of which are included in the mounting kit. If you use the security screw, you
will need a drilled spanner insert bit for size #6 security screws and a screw driver that will accept the bit. The
correct bits are available from Aerohive in sets of three for AP121, AP141, AP330, and AP350 models
(AH-ACC-SEC-BIT-330-AP350-3PK). If you use the slotted screw, you can install it with a standard flat-blade
screwdriver or pan-head driver bit.
1. Insert the security screw or slotted screw through the hole in the chassis.
2. Use a screwdriver with a drilled spanner bit or a flat-blade screwdriver to tighten the screw to the security
tab extension on the rail mount, as depicted in
Figure 7 Locking the AP121 to the mounting plate
USB port
Device lock slot
Turn clockwise to tighten
14
Figure 7, which shows the AP121.
Rail mounting bracket
or mounting plate
Security tab extension
Security tab cavity
Security screw
Screwdriver
Aerohive