Table of Contents
Advertisement
Chapter 2 The AP170 Platform
I
NSTALLING THE
This section explains how to mount a AP170 to a pole or flat surface in virtually any outdoor setting, and
connect it to HiveManager over the network.
Kit Contents, Required Accessories, and Tools
The AP170 kit includes the items shown in
Figure 2
AP170 kit contents
Plane bracket (1)
AP170
To install your AP170, you will need the following accessories (ordered separately) and tools:
•
(2) 2.4 GHz antennas (AH-ACC-170-ANT-2G)
•
(2) 5 GHz antennas (AH-ACC-170-ANT-5G)
•
A switch that provides PoE power, or a PoE provisioning device
•
(1) shielded cat5 Ethernet cable rated for outdoor use; length not to exceed 328 feet (100 m)
•
Crosshead screwdriver for 1/4" (6 mm) x 3/8" (10 mm) screws
•
Drive sockets (nut drivers) for 3/8" (10 mm) nuts
•
Flat blade screwdriver to tighten hose clamp
Safety Instructions and Site Hazard Warnings
Read and follow these safety instructions and hazard warnings before installing a AP170 outdoors. Keep
these instructions for future reference.
•
To comply with RF (radio frequency) exposure limits, do not place the AP170 within 8" (20 cm) of people
when using the omnidirectional antennas that ship with the product. If you are using a point-to-point
mesh directional antenna, do not place the AP170 within 26" (65 cm) of people.
•
You can install the AP170 in wet, windy locations. Therefore, make sure to install the Ethernet cable
housing for a complete waterproof connection.
•
To protect the AP170 from lightning, do not place it at the highest point of a building or structure.
To install the AP170, you must be a qualified installation professional, licensed or certified in
accordance with local regulations.
Use only attachments and accessories specified by Aerohive.
During operation, the surfaces of the AP170 can become hot. Use caution when handling it.
Make sure that the AP170 is connected to a suitably installed ground conductor. Contact the
appropriate electrical inspection authority if you are uncertain that suitable grounding is available.
20
AP170
Figure
Base
bracket (1)
Ground cable (1)
2.
(4) Hex head bolt, 3/8"x1/2"
Hose
strap (1)
(4) Round head screw 1/4"
Ethernet
housing (1)
(4) Sleeve-bolt assembly
(10 mm x 13 mm)
lock washer, flat washer 1/2"
(13 mm)
(6 mm) lock washer,
flat washer
sleeve, 5/8" (16 mm),
bolt 1 15/16" (5 cm),
hex nut 3/8" (10 mm),
washer 5/8" (16 mm)
Aerohive
Hide quick links:
Advertisement
Table of Contents
