Ap110 And Ap120 Product Overview - Aerohive Networks AP121 Hardware Reference Manual

Chapter 3 AP110 and AP120 Platforms
AP110 AP120 P
AND
The AP110 and AP120 are both multi-channel wireless access points. The AP110 contains a dual-band radio
that can operate at either 2.4 GHz or 5 GHz—but not in both bands simultaneously. The AP120 contains a 2.4
GHz radio and a 5 GHz radio that can operate concurrently through four internal antennas. These devices
support a variety of Wi-Fi (wireless fidelity) security protocols, including WPA (Wi-Fi Protected Access) and
WPA2.
You can see the hardware components on the AP in
"AP110 and AP120 component
Figure 1 AP110 and AP120 hardware components
Table 1 AP110 and AP120 component descriptions
Component
Status Indicator
Device Lock Slot
Reset Button
32
RODUCT
descriptions".
Status indicator
Device lock slot
Description
The status indicator conveys operational states for system power,
firmware updates, Ethernet and wireless interface activity, and
major alarms. For details, see
You can physically secure the AP by attaching a Kensington lock
and cable to the device lock slot. For more information, see
the AP" on page
The reset button allows you to reboot the device or reset the AP to its
factory default settings. Insert a paper clip, or something similar, into
the Reset pinhole and press the reset button. To reboot the device,
hold the button down between 1 and 5 seconds.
O
VERVIEW
Figure 1. Each component is described in
Reset pin
PoE port
"Status Indicator" on page
36.
Table 1
ETH0 48 VDC
34.
"Locking
Aerohive