Surface Mount - Aerohive Networks AP121 Hardware Reference Manual

Figure 5 Attaching the AP to the rail mount
4
With the AP upside down, align the two V-shaped tabs and the security
tab extension on the rail mount with the tab slots and security screw
cavity on the AP, and press the AP upward until it snaps into place.
(side view)
V-shaped tab
Tab slot
For the AP350, attach the articulated antennas and swivel them into a vertical position pointing downward
to provide optimal coverage. When done, adjust the ceiling tiles back into their former position.

Surface Mount

You can use the flat mounting plate to attach the AP330 or AP350 to any surface that supports its weight
(AP330: 1.5 lb or 0.68 kg; AP350: 2.375 lb or 1.08 kg), and to which you can screw or nail the plate. First, mount
the plate to the surface, and then attach the device to the plate, as shown in
Figure 6 Mounting the AP on a wall
1
With the two flexible V-shaped tabs at the sides
of the plate extending away from the surface,
attach the mounging plate to a secure object
such as a wall, ceiling, post, or beam.
Cut or drill a hole in the space not covered by
2
the L-shaped mounting plate, pass the cables
through to the AP, and connect them. (You can
also run the cables along the wall to the AP
instead of through a hole.)
Depending on how the device is powered and
how it connects to the network, connect a power
cable and one or two Ethernet cables. (The
cables are not shown in this illustration.)
3
Align the tabs and security tab extension on the
mounting plate with the tab slots and security
screw cavity on the AP.
4
Push the AP against the mounting plate until the
tabs click inside the tab slots.
Hardware Reference Guide
Security tab extension
V-shaped tab
Tab slot
Security screw cavity
(Bird's eye view)
V-shaped
tab
Tab slot
M AP330
OUNTING THE OR
Figure 6.
Security tab
extension
V-shaped tab
Tab slot
Security screw
cavity
AP350
45