Status Leds; Mounting And Installation - Aerohive Networks AP121 Hardware Reference Manual

Status LEDs

The device status LED on the angled edge of the BR100 indicates various states of activity by color (dark,
amber, and white) and illumination pattern (steady glow or flashing). The link status LEDs indicate link activity
for the ports by color (dark, green) and illumination pattern (steady glow or flashing). The meanings of the
various color and illumination patterns are explained below.
Device Status LED
Dark
• : No power
Amber
• (steady): Powered on and the firmware is running normally. If the LED remains steady amber
and does not turn white, there may be an issue with IP tracking, which is enabled by default. If a
reset does not correct the problem, contact your IT administrator.
Amber
• (flashing): Device is performing a firmware upgrade. Do not turn the device off while the LED
is flashing.
White
• (steady): The device has made a CAPWAP connection to HiveManager and is operating
properly.
White
• (flashing): Device is operating in a failover state using the USB modem.
Link Status LEDs
Dark
• : No link
Green
• (steady): The Ethernet link is up but inactive
Green
• (flashing): The Ethernet link is up and active
M
OUNTING AND
You can set the BR100 router on a desktop or mount it on a wall using the wall mount keyholes on the
bottom of the device. Figure 3
Figure 3 Mounting the BR100 on a wall
Center-to-center
1 and 7/8 inch
(4.76 cm)
Keyholes for wall mount
To mount the device on a wall, first install two drywall screws 1.875" (4.76 cm) apart in a wall. The heads of
the screws cannot be wider than 0.25" (0.64 cm) so that they will fit inside the openings in the keyholes. Place
the device over the screws and press it down to secure it to the wall.
Hardware Reference Guide
I
NSTALLATION
shows these keyholes.
Feet for surface
mount (4)
M I
OUNTING AND NSTALLATION
53