Status Leds; Mounting And Installation - Aerohive Networks AP121 Hardware Reference Manual

For aps, routers, and hivemanager devices
Hide thumbs Also See for AP121:
Table of Contents

Advertisement

Chapter 6 BR200 and BR200-WP Routers

Status LEDs

The status LED on the top corner of the router indicates various states of activity by color (dark, amber, and
white) and pattern (steady or flashing). The link status LEDs indicate port activity and speed by color (dark,
green, or amber) and illumination pattern (steady or flashing). For BR200-WP models, the PoE status LEDs
indicate PoE power delivery. The meanings of the various color and illumination patterns are explained
below.
Device Status LED
Dark
: No power.
Amber
(steady): Powered on and the firmware is running normally.
Amber
(flashing): Device is performing a firmware upgrade. Do not turn the device off while the LED
is flashing.
White
(steady): The device has made a CAPWAP connection to HiveManager and is operating
properly.
White
(flashing): Device is operating in a failover state using the USB modem.
Link Status LEDs
Dark
: No link.
Green
(steady): The Ethernet link is up but inactive at 1000 Mbps.
Green
(flashing): The Ethernet link is up and active at 1000 Mbps.
Amber
(steady): The Ethernet link is up but inactive at 10/100 Mbps.
Amber
(flashing: The Ethernet link is up and active at 10/100 Mbps.
PoE Status LEDs (BR200-WP)
Dark
: No power is being provided through the port.
Green
(steady): Port is delivering PoE normally to powered device.
Amber
(steady): The port is experiencing a power overload.
M
OUNTING AND
You can set BR200 series routers on a desktop or mount them on a wall using the wall mount keyholes on the
bottom of the device.
Figure 3
Figure 3
BR200 series router wall-mount keyholes
Keyholes for wall mount
To mount the device on a wall, first install two drywall screws 5.875" (14.92 cm) apart in the wall. The heads of
the screws must not be wider than 0.25" (0.64 cm) so that they will fit inside the openings in the keyholes.
Place the wide section of keyholes over the screws and press the device down to secure it to the wall.
60
I
NSTALLATION
shows the wall mount keyholes.
Feet for surface
mount (4)
Aerohive

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents