Operation Instructions - Mile Marker PE2.5 Installation And Operator's Manual

Function Testing
After checking all connections in accordance to installation instructions prior, connect power cables to vehicle's battery. Attach Black Cable to
Negative (-) Battery Terminal and secure, followed by attaching the Red Cable to Positive (+) Battery Terminal.
1. Before testing the winch, turn the clutch handle to the "Freespool" position. Always wear heavy gloves when handling winch cable. Using a
Mile Marker hook strap, pull about two feet of cable off the winch drum, and place the clutch handle in the "Engaged" position (fig. 3-1).
2. Toggle the Joystick "down" to retrieve line. When using the handlebar remote, you can also toggle the "IN" button for the same retrieval
function (fig. 3-2). Winch cable will spool in on drum.
NOTE: If cable is spooled "Out" while pressing the "IN" function, please refer to Figure 2-1, and switch power cables to opposite studs on motor.
3. Toggle the Joystick "up" to Power Out winch cable. When using the handlebar remote, you can also toggle the "OUT" button for the same
Power Out function (fig. 3-2). Winch Cable will spool out off of drum.
NOTE: The "OUT" function is for INTERMITTENT USE ONLY, as you are powering drum against the brake, and can damage internal mechanism.
4. If any of the above functions are not working properly, recheck all connections in accordance with Installation Section of this manual, or refer
to Troubleshooting Section in back of manual.
WINCH OPERATION
Page 8
3-1: Clutch Function Diagram
3-2: Remote Control Function Diagram