Winch Operation - Mile Marker SEC18 Installation & Operator's Manual

1. Disengage the clutch by moving the clutch handle to the disengaged position
2. Grab assembly hook with hand strap and pull cable
NOTE: Always leave at least 5 turns of cable on the drum. Review safety warnings on page 1.
3. Attach to item being pulled
Recommended: Place winch cable dampener over cable
4. Reengage the clutch by moving handle to engaged position
5. Remove socket cover on the solenoid and insert the plug of the remote control (Fig. 5)
6. While standing outside of the tow path, push the button on the remote forward and backward (Fig. 6 and Fig. 7) to check winch
running directions. Wait until the motor stops before reversing directions.
CAUTION: Do not power winch out for more than 10 seconds at a time. This may cause damage to the brake system.
Remote control
7. Stand back when pulling. When complete, rewind the cable onto the drum.
Cable must be rewound under a load of at least 500 pounds to prevent damage to the cable
8. Remove the remote from the socket and replace socket cover
CAUTION: It is important to make sure the winch is mounted on flat surface to guarantee the 3 major sections of the winch (the motor end,
the cable drum and the gear housing end) are properly aligned. Run the vehicle engine during pulling operations to keep the
battery charging.
PAGE 5

WINCH OPERATION

Solenoid assembly
2121 Blount Road, Pompano Beach, FL 33069
IN
Fig. 5
Fig. 6
Fig. 7
OUT
MileMarker.com 1.800.886.8647