Alarm Unsetting; Partial Alarm Setting - jablotron 100+ User Manual

2. OPERATING THE JABLOTRON 100 + SYSTEM

2.2.1.2 ALARM UNSETTING

1. When you enter the building
(triggering a detector with
a "Delayed zone" reaction),
the system starts indicating
an entrance delay with a continuous
tone, the system indicator and
a function button, both flashing red,
of the section in which the delayed
entrance has been triggered.
Note: If the "Unset section by authorization only during entrance delay" parameter is enabled, then mere
authorization will unset a section where the entrance delayed has been triggered. This option should
be used with caution when using multiple sections.
Consult the installation with a service technician in order to program the desired behaviour of the system.

2.2.1.3 PARTIAL ALARM SETTING

WARNING: This is an additional function of the alarm system.
The system can also be configured to be partially set which allows guarding only by certain detectors
in a section.
Example: At night, it is possible to set the door and window detectors only, while selected motion detectors
will not trigger the alarm when somebody moves inside the section.
1. Authorize yourself using
the keypad (enter a code
or hold an RFID card or tag
up to the reader). The system
indicator button will start flashing
green.
2. Authorize yourself using
the keypad – the system indicator
will start flashing green.
3. Press the function buttons
of the sections you want to unset.
2. Press the function button
of the selected section.
4. The command is executed.
The function buttons and
the system indicator turn green
to indicate unset sections.
3. The command is executed
and the function button turns
permanently yellow to indicate
a partially set section.
15