Ack Nak Timeout Value; Ack Nak Retry Count - Datalogic Gryphom 4500 Series Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK character from the
host following label transmission. The selectable timeout range is 200 milliseconds to
15,000ms (15 seconds) in 200ms increments. A selection of 0 disables the timeout. See
"
ACK NAK Timeout Value" on page 270
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label transmission due to
a retry condition. The selectable range is from 1 to 254 retries. A selection of 0 disables
the count, and a selection of 255 specifies unlimited retries. See "
on page 271
Select ACK NAK Retry Count Setting
$CR2AR
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
46
GRYPHON™ I GD/GBT/GM4500
$CR2AT

01 ACK NAK Timeout value is 200ms
for more detailed programming instructions.

for more detailed programming instructions.
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.
003 = 3 Retries
RS-232/USB-COM INTERFACES
Appendix D
CANCEL
ACK NAK Retry Count"
Appendix D
CANCEL