Removing The I/O Module; Figure 8: Snap The I/O Module Into Place (Example); Figure 9: Removing The I/O Module (Example) - WAGO 750-1515/040-000 Manual

WAGO-I/O-SYSTEM 750 XTR
750-1515/040-000 8DO 24VDC 0.5A 2-Wire XTR

Figure 8: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or
to the previous or possibly subsequent I/O module are established.
Pos : 23.12 /Serie 750 ( WAGO-I/O-SYST EM)/Monti eren/D emonti eren/XTR-I/O-Modul entfernen @ 28\mod_1486551166032_21.doc x @ 405491 @ 3 @ 1
5.2.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.

Figure 9: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Pos : 24 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Mounting 35
Manual
Version 1.3.0