Start Frequency; Stop Frequency - Agilent Technologies PSA Series Manual

Notes:
Remote Command
Notes:

4.1.5 Start Frequency

Information parameter which displays the start frequency of the signal source connected at the specified IP
Address.
Mode:
Key Path:
Remote Command:
State Saved:
Dependencies and
Couplings:
Remote Command
Notes:
Example:

4.1.6 Stop Frequency

Information parameter which displays the stop frequency of the signal source connected at the specified IP
Address.
Mode:
Key Path:
Remote Command:
State Saved:
Chapter 4
This parameter is not user definable and is provided purely for
information. It is simply displaying the serial number of the
instrument recognized to be at the IP Address you entered.
Front panel information only
Spectrum Analysis
Source, Ext Src Config, Show Setup
:SOURce:EXTernal:FREQuency:STARt?
No
The external source start frequency is changed each time the
start frequency of the PSA changes.
If the calculated external source start frequency exceeds the
frequency range of the external source Error Message 13227
will be reported and the sweep stopped until you adjust either
PSA Start Freq, PSA Stop Frequency, Frequency Offset (if ON)
or Harmonic (if ON) such that the frequency range can be swept
by the signal source and PSA simultaneously.
Query only
SOUR:EXT:FREQ:STAR?
Spectrum Analysis
Source, Ext Src Config, Show Setup
:SOURce:EXTernal:FREQuency:STOP?
No
Source Key and Programming Commands
External Source Configuration
49