Agilent Technologies PSA Series Manual page 25

1. Press the
2. Press
the second softkey label.
Enter the IP Address of the external source into the PSA Series
analyzer.
3. Press the
the PSA Series analyzer into Spectrum Analysis mode.
4. Press the Source key to display the
5. Press the
IP address of an external signal source. If this IP address does not
match the IP address of your external source (from Step 2 above),
then you need to change it using Steps 6 and 7.
6. Press the
7. Enter the IP Address of the external source using the numeric
keypad, and press the
If you are using a cross-over LAN cable to connect the instruments
NOTE
directly together, then the IP addresses of both the instruments must
start with the same two integers. That is, if the spectrum analyzer IP
address is 156.121.12.122, the source IP address must be
156.121.xxx.xxx.
Chapter 1
key on the front panel.
Utility
, then
GPIB/RS-232 LAN
key followed by the
MODE
softkey to display the current value for the
Ext Src Config
softkey so that the key label is highlighted.
IP Address
key.
Enter
Setting Up Your Signal Analyzer and Signal Source
to display the IP Address on
LAN Setup
Spectrum Analysis
menu.
Ext Source
Getting Started
softkey to put
25