Hardware And Firmware Requirements - Agilent Technologies PSA Series Manual

Hardware and Firmware Requirements

One of the following Agilent spectrum analyzers and associated
hardware options is required to run Option 215 External Source
Control.
Option 215 External Source Control requires the gated sweep
NOTE
functionality that is provided by the more recent LO synthesizer and
front end driver hardware. The part numbers of the boards providing
this gated sweep functionality are shown in
Table 1-1
Analyzer
Model
Number
E4440A
E4443A
e
E4445A
E4446A
E4447A
E4448A
a. Firmware A.11.00 or later is required for MXA support. Firmware
A.07.09 is required for ESG-C and PSG support for all PSA models
except E4447A where firmware A.08.06 or greater is required.
b. Press
your front end driver board.
c. If you do not have the required hardware, you can order Option
426 to upgrade the hardware.
d. Press
your LO synthesizer board.
e. Option 215 will not run on a model E4445A which has the HA5
"Restricted Performance" option installed.
Chapter 1
Compatible Agilent PSA Series Spectrum Analyzers
Upper
Firmware
Frequency
Limit
26.5 GHz A.11.00 or
later
6.7 GHz A.11.00 or
later
13.2 GHz A.11.00 or
later
44.0 GHz A.11.00 or
later
42.98 GHz A.11.00 or
later
50.0 GHz A.11.00 or
later
, ,
System More 1 of 3 Show Hdwr
, ,
System More 1 of 3 Show Hdwr
Hardware and Firmware Requirements
Table 1-1.
a Front End LO
Synthesizer
b c
Driver
Board
Any EXCEPT
part numbers
E444060242 or
E444060002
Any EXCEPT
part number
E444060008
Any EXCEPT
part numbers
E444660059 or
E444660006
to show the part number of
to show the part number of
Getting Started
d c
7