Selection And Adjustment - EWM tigSpeed continuous drive 45 coldwire Operating Instructions Manual

Wire feed unit

Hide thumbs Also See for tigSpeed continuous drive 45 coldwire:

Table of Contents

5.1.15 Selection and adjustment

To set the welding programs, you can use the machine control. The left hand display shows the wire feed

speed, the right hand display shows further parameter settings such as program number or hot wire cur-

rent (for hotwire only). The operating mode is identical for all programs.

The following selection is an example of use:

099-000237-EW501

25.04.2019

Design and function

Figure 5-20

Transport and installation

Table of Contents

Do you have a question about the tigSpeed continuous drive 45 coldwire and is the answer not in the manual?