7
Configuring and adjusting
DANGER!
Risk of personal injury and equipment damage due to non-compliance with safety information!
If you fail to observe the safety information, you risk creating operating conditions at the dispensing valve which
may cause personal injury or damage to equipment.
•
Please always strictly observe all safety measures and information/instructions, see chapter 1.
NOTICE!
All installation, maintenance and repair work on the dispensing valve must be carried out by an expert only.
WARNING!
Risk of personal injury and equipment damage due to operation by non-qualified staff!
It is dangerous for non-qualified staff to operate the unit!
•
Service operations on the dispensing valve may only be carried out by trained and certified experts who
have been trained in undertaking service operations on the dispensing valve.
•
All wiring and plumbing must be carried out in compliance with national and local laws, regulations and
guidelines. Non-compliance with these laws, regulations and guidelines may result in death, serious injury
or equipment damage.
7.1
Configuring portion control
The dispensing valve module is factory-programmed with fill times. These fill times for each beverage size are listed in the following
table:
Beverage size
S
M
L
XL
Tab. 7-1 Fill times factory setting
Installation and service manual Dispensing valve
UFB1
24
Fill time
2 seconds
3 seconds
4 seconds
6 seconds
Configuring and adjusting
Cornelius Deutschland GmbH
Document no. TD2004100
Version 15/03/2019, Index 0