Table of Contents
Advertisement
Installer manual Fleck 5600 SXT - Programming
Info
Setting a cycle step to 0 will cause the controller to skip that step during regeneration,
but keeps the following steps available.
The different regeneration cycles are listed in sequence based on the regeneration
flow selected for the system.
All cycles can be set from 0 to 199 minutes.
6.5.14.1 Regeneration abbreviations
B1
First backwash
B2
Second backwash
BD
Brine draw
6.5.14.2 For pre-set regeneration cycles
1. Press
or
2. Press
to validate the selection and move to the next parameter.
3. Repeat the two previous steps for each cycle.
6.5.15
Day of week (Dn, n = 1 to 7)
Set the day of week for regeneration.
Info
The day of week parameter is only available if "day" mode has been set in controller
type selection.
1. Press
or
day.
2. Press
to validate the selection.
3. Repeat the two previous steps until D7 is set.
4. Press
to validate the selection and move to the next parameter.
6.5.16
Current day (CD)
Set the current day.
Info
The current day is defined from D1 (Monday) to D7 (Sunday).
1. Press
or
2. Press
to validate the selection and move to the next parameter.
6.5.17
Flow meter type (FM)
Select the flow meter type.
62 / 104
to set the regeneration cycle time.
to set "ON" or "OFF" to set the day as a regeneration
to set the current day.
BF
Brine fill
BW
Backwash
RR
Rapid rinse
Ref. MKT-IM-013 / E - 23.09.2020
Advertisement
Table of Contents
