Day Of Week (Dn, N = 1 To 7) - Pentair FLECK 9100 SXT Installer Manual

Installer manual Fleck 9100 SXT - Programming
Info
Setting a cycle step to 0 will cause the controller to skip that step during regeneration,
but keeps the following steps available.
The different regeneration cycles are listed in sequence based on the regeneration
flow selected for the system.
All cycles can be set from 0 to 199 minutes.
6.5.14.1 Regeneration abbreviations
B1 First backwash
B2 Second backwash
BD Brine draw
6.5.14.2 For pre-set regeneration cycles
1. Press or
2. Press to validate the selection and move to the next parameter.
3. Repeat the two previous steps for each cycle.
6.5.14.3 For regeneration flow Other
Info
The regeneration cycles are identified as R1 to R6.
1. Press or
2. Press to validate the selection and move to the next regeneration
cycle.
3. Repeat the two previous steps for each cycle.
6.5.15 Day of week (Dn, n = 1 to 7)
Set the day of week for regeneration.
Info
The day of week parameter is only available if "day" mode has been set in controller
type selection.
1. Press or
day.
2. Press to validate the selection.
3. Repeat the two previous steps until D7 is set.
4. Press to validate the selection and move to the next parameter.
54 / 108
to set the regeneration cycle time.
or to set the regeneration time of this cycle.
to set "ON" or "OFF" to set the day as a regeneration
BF Brine fill
BW Backwash
RR Rapid rinse
Ref. MKT-IM-004 / E - 06.10.2020