Wiring Instructions (Hardwired Lcs) - ClipperCreek LCS Series User Manual

LCS User's Manual

WIRING INSTRUCTIONS (Hardwired LCS)

Route the LCS conduit to a nearby service panel or junction box. Use the
included ¼" trade size watertight fitting to provide a moisture-resistant seal with
the service panel or junction box. If necessary, drill a 1/2" diameter hole to
accommodate the liquid-tight fitting or use the included 1/4" NPT to 1/2" NPT
thread reducer kit.
Figure 7 - Wiring the LCS in a junction box
NOTE Before connecting the LCS service
conductors, please carefully read the section
of this manual titled Service Connections
on page 10. If you are unsure of the type of
power provided at the service panel, please
consult with your local utility or call your
Service Representative for assistance.
NOTE
The three LCS service conductors use
stranded 12AWG, 75ºC copper wire. The
insulation of each conductor is color coded
for standard 240VAC installation:
Green: Ground
Black: Line 1 (120VAC to Ground)
Red:
Les trois conducteurs service la LCS utiliser
multibrins 12 AWG, 75ºC fil de cuivre.
L'isolation de chaque conducteur est un code
couleur pour une installation standard de 240
V CA:
Vert:
Noir:
Rouge: Ligne 2 (120VAC à Mise à la Terre)
Page 17
Line 2 (120VAC to Ground)
Mise à la Terre
Ligne 1 (120VAC à Mise à la Terre)