Grounding Instructions; Moving & Storage Instructions - ClipperCreek LCS Series User Manual

GROUNDING INSTRUCTIONS

This product must be grounded. If this product should malfunction or break
down, grounding provides a path of least resistance for electric current to reduce
the risk of electric shock.
For the hardwired LCS:
The hardwired LCS is equipped with three service conductors shielded by three
feet of flexible conduit. This product must be connected to a grounded, metal,
permanent wiring system, or an equipment-grounding conductor must be run
with the circuit conductors and connected to the ground lead on the product.
For the plug-in LCS-P:
The plug-in LCS-P is equipped with a cord having an equipment grounding
conductor and a grounding plug. The plug must be plugged into an appropriate
outlet that is properly installed and grounded in accordance with all local codes
and ordinances.
WARNING: Improper connection of the equipment-grounding
conductor may result in a risk of electric shock. Check with a qualified
electrician if doubt exists as to whether the product is properly
grounded. Do not modify the plug provided with the product – if it will
not fit the outlet, have a proper outlet installed by a qualified electrician.
AVERTISSEMENT: Une mauvaise connexion du conducteur de terre
peut entraîner un risque de choc électrique. Vérifier avec un électricien
qualifié si il existe un doute quant à savoir si le produit est correctement
mis à la terre. Ne pas modifier la fiche fournie avec le produit – si elle
n'entre pas dans la prise, faites installer une prise adéquate par un
électricien qualifié.
MOVING & STORAGE INSTRUCTIONS
Note that both the hardwired LCS and the plug-in LCS-P are intended for fixed
installations. For mounting requirements, consult the Mounting Procedures
section of the Installation Instructions in this manual.
Aways turn off input power to the charge station at the circuit breaker panel
prior to hard-wiring an LCS to or disconnecting an LCS from the service lines.
Likewise, always turn off input power to the charge station at the circuit breaker
panel prior to plugging an LCS-P into or unplugging an LCS-P from a NEMA
socket.
When transporting the charge station, do not lift or carry the entire unit by the
charge cord. Likewise, do not lift or carry the entire unit by the
SAE-J1772
TM
flexible conduit and input conductors (LCS) or the NEMA plug (LCS-P).
The charge station has a non-operational storage temperature range of -40°C to
+80°C (-40°F to +176°F).
Page 20
LCS User's Manual