Fcc Information; Operation - ClipperCreek LCS Series User Manual

FCC INFORMATION

This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference
that may cause undesired operation.
This product has been designed to protect against Radio Frequency Interference
(RFI). However, there are some instances where high powered radio signals or
nearby RF-producing equipment (such as digital phones, RF communications
equipment, etc.) could affect operation.
If interference to your charge station is suspected, we suggest the following
steps be taken before consulting your ClipperCreek Sales and Service
Representative for assistance:
1. Reorient or relocate nearby electrical appliances or equipment during
charging.
2. Turn off nearby electrical appliances or equipment during charging.
CAUTION: Changes or modifications to this product by other than an
authorized service facility may void FCC compliance.
ATTENTION: Modifications apportées à ce produit par quiconque
autre qu'un centre de service autorisé peut annuler la conformité FCC.

OPERATION

The LCS Electric Vehicle Charging Station is a compact wall-mounted charging
station that provides the Plug-in Hybrid or Battery Electric Vehicle (together
Plug-In Electric Vehicles, or "PEV") user with a safe and manageable link be-
tween the power grid and the PEV. Both hardwired (LCS) and NEMA plug-
equipped (LCS-P) versions are available.
The LCS is very easy to use. Just unwrap the SAE-J1772
plug the charge coupler firmly into the vehicle's charge port.
Normally, the vehicle will immediately request a charge using a special commu-
nication line in the cable. Within a few seconds the green "Charging" light on
the face of the LCS will turn on and the charging cycle will begin. After an av-
erage driving day the vehicle battery pack will require several hours to recharge
completely. Charging overnight is the most convenient way to maintain healthy
batteries and ensure the vehicle's full range will be available for the next day.
When the vehicle has stopped charging the green "Charging" light on the LCS
will turn off. To remove the charge coupler once a charge cycle has completed
(or to interrupt a charge in progress) press and hold down the latch release lever
on the charge coupler handle then unplug the charge coupler from the vehicle
charge port.
Page 8
LCS User's Manual
charge cable and
TM