Setting System Output; Setting Printer Port Output; Master Reset - JRC JFE-680 Instruction Manual

Setting System Output

・Make SYSTEM a yellow display, press
Set content ：OFF/ON
OFF
ON
・Select the content by

Setting Printer Port Output

・ Make PRINTER PORT OUT a yellow display, press
set content.
Set content ：PRINTER/PC
PRINTER
PC
・Select the content by
Maintenance menu operation is written in "6.2 Maintenance Function"

4.8 Master Reset

The buzzer sounds when turning on the power while pressing the [MENU] key and the [CLR] key at the
same time and master reset is executed. All set values except the date and time return to the factory
shipment value.
When master reset is completed, the following screen is displayed.
Please do connection setting of transducers.
OFF
200kHz
50kHz
A primary transducer is set on this screen. When the [ENT] key is pressed after the frequency of the
connected transducer is selected, it changes into the primary transducer setting menu of the initial setting
menu.
Refer to 4.5 Initial Setting on page 27 for the following setting methods.
When turning on the power for the first time after installing it, this screen is displayed.
4. Operation 40
：Maintenance system information is not output with the constant period.
：Maintenance system information is added to the depth output port and it outputs.
and press the [ENT] key.
：The signal for the printer control is output.
：Maintenance system information is output to the printer port.
The output content follows the setting of menu "PRINTER CONT>PRINT MODE".
and press the [ENT] key.
or the [ENT] key, and select it from the following, set content.
or the [ENT] key, and select it from the following,
(Refer to 4.6 Printer Control Setting.)