Setting Depth Alarm; Alert Cont; Depth Setting - JRC JFE-680 Instruction Manual

Setting Depth Alarm

・ Make DEPTH ALARM a yellow display, press
displayed.
DEPTH ALARM

ALERT CONT

DEPTH SETTING

「ALERT CONT」
◎ The operation of the depth alert is selected.
・Make ALERT CONT a yellow display, press
content.
Set content ：OFF/ON
OFF
ON
・Select the operation by
「DEPTH SETTING」
◎Depth where the depth alert starts is set.
・Make DEPTH SETTING a yellow display, press
value 0.0) is displayed.
・The numerical value becomes large when
numerical value becomes small.
・Depth can be set up to 99.9m by a 0.1m unit.
・When depth is set and the depth alert is made "ON", the depth alert mark is displayed at the set depth
position on the right of the range scale. This mark is not displayed to make the depth alert "OFF".
・After the depth setting finishes, press the [ENT] key.
<Example>
・When the alert depth is set to 10.0m, alert starts by 9.9m though it doesn't start by 10.0m.
4. Operation 22
OFF
・Selecting items move a yellow display with
0.0
： The depth alert doesn't operate.
： When sea bottom becomes shallower than the depth set by "DEPTH SETTING", the
depth alert starts.
When sea bottom becomes deeper than a set value after the depth alert starts, it
releases.
and press the [ENT] key.
or the [ENT] key, and the following menu is
or the [ENT] key, and select it from the following, set
or the [ENT] key, and the numerical value (initial
key is pressed, and when
or key.
key is pressed, the